# Question: What Is The Main Function Of Darlington Transistor?

## How do you make a Darlington pair?

Darlington pair circuit calculations & design exampleDetermine the emitter current: This is usually the starting point for the design.

Determine the emitter voltage: This would normally be approximately half the rail voltage as this will give the maximum voltage swing at the output.More items….

## What is the current gain?

The current gain for the common-base configuration is defined as the change in collector current divided by the change in emitter current when the base-to-collector voltage is constant. Typical common-base current gain in a well-designed bipolar transistor is very close to unity.

## When multiple transistors are in parallel?

Transistors are generally used in parallel when the current is more than a single transistor could take. It’s an issue if how much power the transistor can dissipate – if 2A through a typical transistor would destroy the transistor (information is on the datasheet) then you put another transistor in parallel with it.

## How does a transistor work?

A transistor works when the electrons and the holes start moving across the two junctions between the n-type and p-type silicon. … By turning a small input current into a large output current, the transistor acts like an amplifier. But it also acts like a switch at the same time.

## What is the main function of a transistor?

A transistor is a semiconductor device used to amplify or switch electronic signals and electrical power. It is composed of semiconductor material usually with at least three terminals for connection to an external circuit.

## How do you make a Darlington transistor?

Let’s begin by making the darlington pair. Put one of the transistors in the breadboard. Now place the second transistor in the breadboard, such that the collector terminals of both transistors are connected. and the emmiter terminal of second transistor is connected to the base of first transistor.

## What is the main function of emitter?

Emitter: Emitter terminal is the heavily doped region as compared two base and collector. This is because the work of the emitter is to supply charge carrier to the collector via the base. The size of the emitter is more than base but less than the collector.

## Which circuit uses photo Darlington devices?

The photo-transistor and photo-darlington devices are mainly for use in DC circuits while the photo-SCR and photo-triac allow AC powered circuits to be controlled. There are many other kinds of source-sensor combinations, such as LED-photodiode, LED-LASER, lamp-photoresistor pairs, reflective and slotted optocouplers.

## How many ways are there to connect a transistor?

There are three ways to connect transistors; as Common-Emitter, Common-Collector and Common-Base.

## What does a Darlington transistor do?

A Darlington transistor acts as a single transistor with high current gain, it means that a small amount of current is used from a microcontroller or a sensor to run a larger load. … The below Darlington circuit is built with two transistors shown in the circuit diagram.

## What is the advantage of a Darlington pair?

The Darlington Pair offers a number of advantages. It is primarily used because it offers a particularly high current gain and this also reflects into a high input impedance for the overall Darlington circuit when compared to a single transistor.